< img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=2845724332249608&ev=PageView&noscript=1"/>
Commands and instructions for viewing port status on Huawei switches.1.25g 1312nm smf sfp module Production
You are here: Home » Blog » Fiber optic equipment factory » Commands and instructions for viewing port status on Huawei switches.1.25g 1312nm smf sfp module Production

Commands and instructions for viewing port status on Huawei switches.1.25g 1312nm smf sfp module Production

Views: 0     Author: Site Editor     Publish Time: 2023-06-16      Origin: Site

whatsapp sharing button
linkedin sharing button
line sharing button
facebook sharing button
sharethis sharing button

1 (8)

Current state: The current state of the port is as follows: DOWN indicates the port is closed, UP indicates the port is open;

Last 300 seconds input rate: The byte rate and message rate received by the port in the first 5 minutes;

The working mode of the Port Mode: COMMON COPPER is the electrical port mode, and COMMON FIBER is the optical port mode;

Last 300 seconds output rate: The byte rate and message rate sent by the port in the first 5 minutes;

Switch Port: displays the port as a second layer port. If the port is a three-layer port, it will be displayed as a Route Port here;

Input peak rate 0: The maximum rate of incoming port packets and the occurrence time of the maximum rate;

Line protocol current state Port link protocol state: DOWN indicates a failure in the port link protocol layer or no IP address configured for the port, UP indicates that the port link protocol is in a normal startup state;

Output peak rate 0: The maximum rate of output port packets and the occurrence time of the maximum rate;

Description: Port description information;

Input: The total number of received messages, and output is the total number of sent messages;

MDI: Network cable type of the port;

Discard: The number of discarded packets discovered by the port during physical layer detection;

Hardware address: The MAC address of the device;

Total error: The total number of error messages discovered by the port during physical layer detection;

PVID: The default number of VLANs for the port;

CRC: The number of CRC error messages received by the port;

Speed: Current port speed;

Dropevents: The number and rate of packet loss caused by memory pool full or back pressure in packets received by the port;

Duplex port working duplex mode: FULL full duplex mode, HALF half duplex mode;

Alignments: The number of packets received by the port with frame alignment errors;

TPID displays the frame types supported by the port: By default, TPID is 0x8100, indicating 802.1Q frames (this field is only displayed when the port type is a Layer 2 port)

Symbols: The number of encoded error messages received by the port;

The Maximum Frame Length: The maximum frame allowed by the port;

Buffers Purged: The number of aged messages that have been in the queue buffer for too long when the port sends messages;

IP Sending Frames' Format IP protocol sending frame format: including PKTFMT_ ETHNT_ 2. Ethernet_ 802.3 and Ethernet_ SNAP;

Input/Output bandwidth utilization threshold: input/output bandwidth utilization threshold;

Negotiation port self negotiation status: ENABLE indicates that the port's self negotiation function is turned on, and DISABLE indicates that the port's self negotiation function is turned off;

Loopback: Port loopback configuration;

Leave a Message
Customer Message

QUICK LINKS

PRODUCTS CATEGORY

SOLUTIONS

Tel/WhatsApp

+86-755-89582791 / +86-13823553725

Copyright  2024 Shenzhen HS Fiber Communication Equipment CO., LTD. All rights reserved. Sitemap | Privacy Policy | Vulnerability Management Policy | Supported By leadong.com